User Tools

Site Tools


replicator_agent_user_configuration

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
replicator_agent_user_configuration [2017/04/25 11:53]
willm
replicator_agent_user_configuration [2017/04/25 11:54] (current)
willm
Line 1: Line 1:
 ===== Agent User Configuration ===== ===== Agent User Configuration =====
  
-Once you've done the initial installation of your Replicator Agent you can configure which user the agent should run as by performing the task below.+Once you've done the initial installation of your Replicator Agent you can configure which user the agent should run as.
  
 You can set the user in which the agent runs by editing the bin/agent file and set the RUN_AS_USER= directive. This directive is commented out by default. In order to set it you remove the leading # and then enter the name of the user following the '​RUN_AS_USER'​ directive. For example, to configure the user '​perspectium'​ your entry would look like the following: ​ You can set the user in which the agent runs by editing the bin/agent file and set the RUN_AS_USER= directive. This directive is commented out by default. In order to set it you remove the leading # and then enter the name of the user following the '​RUN_AS_USER'​ directive. For example, to configure the user '​perspectium'​ your entry would look like the following: ​
replicator_agent_user_configuration.txt ยท Last modified: 2017/04/25 11:54 by willm